6
1. Cut a hole in the table surface according to the size shown in the drawing. For the purpose of installation and use,
a minimum of 50mm space shall be preserved around the hole. Be sure the thickness of the table surface is at least
30mm. Please select heat-resistant surface material to avoid deformation caused by the heat. As shown in Figure
(1).
2.
Ensure the ceramic hob is well ventilated and the air inlet and outlet are not blocked. Ensure the ceramic hob is
in good working state. As shown in Figure (2).
3.
Fix the hob on the table by screw four brackets on the bottom of hob (see picture) after installation. Adjust the
bracket position to suit for different tabletop thickness.
INSTALLATION
