14
�
�
��
�
�
��
�
10
9
8
�
7
OvEN FAN FILTEr (fig. 7)
- bottom oven unit
The oven is fitted with a fan protector filter to prevent
excessive airborne fat from clogging the fan.
After each use, we recommend cleaning the filter
thoroughly (by hand or in the dishwasher).
To remove, push the tab (F) upwards (see figure).
To refit, repeat the above in reverse order, taking care
that the rear tabs are seated in the relative holes at
the back of the oven.
OvEN SIDEWALL GrIDS (fig. 8)
- bottom oven unit
To allow for a better cleaning of the side grids, you can
extract them this way:
• Push with a finger on the last of the slots to release
the grid from its hold (A).
• Lift it towards the top and extract the grid.
To put them back into place, reverse the order of this
operation.
SELF-CLEANING PANELS
- bottom oven unit
Oven walls are protected by panels coated with a
grease-proof, microporous enamel that absorbs and
eliminates splattering during baking.
If there is a lot of liquid or grease, dry immediately with
a damp sponge and heat the oven for 2 hours on the
maximum thermostat position. Wait for the oven to cool
down and then go over it again with a damp sponge.
If you are unable to remove all the substances, repeat
the above procedure.
It is, however, advisable to periodically remove the
panels and wash them with warm soapy water and dry
them with a soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in the previous
paragraph.
• Remove both side panels (PL) (fig. 9).
• Remove back panel by unscrewing respective
locking screws (V) (fig. 10).
• Repeat previous operations in reverse order to
replace all elements.
IMPORTANT!! Position both side panels (PL) by taking
the locking pin (A) out of the hole (B) (fig. 9).
INSTRUCTIONS FOR THE USER
