Parrot Uncle F4712110V, Use And Care Manual

AFTER INSTALLATION

The fan blades have been adjusted in the factory to minimize any wobble

NOTE:CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY 

ARE MOUNTED ON A RUBBER CROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE 

CEILING, IT WOULD CAUSE EXCESS VIBRATION. MOVEMENT OF A FEW CENTIMENTERS 

IS QUITE ACCEPTABLE AND DOES NOT SUGGEST ANY PROBLEM

WOBBLE

”

TO  REDUCE  THE  FAN  WOBBLE:  PLEASE  CHECK  THAT  ALL  SCREWS  WHICH  SECURED  THE MOUNTING

BRACKET AND DOWNROD ARE SECURE.

BALANCING A WOBBLING CEILING FAN:

For your convenience, a Balancing Kit is included; please follow this procedure when balancing the fan:

1.Check that all blade and blade arm screws are secure.
2.Most fan wobbling problems are caused when blade levels are unequal. Check this level by 
selecting a point on the ceiling above the tip of one of the
blades. Measure this distance.Rotate the fan until the next blade is positioned for 
measurement. Repeat for each blade. The distance deviation should be equal within 
1/8"(0.32cm).
3.Use  the  enclosed Blade  Balancing  Kit  if  the  blade
wobble is still noticeable.
4.If the blade wobble is still noticeable, interchanging two
adjacent (side by side) blades can redistribute the weight and possibly result in smoother 
operation. WARNING: TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE 
BLADE ARM WHILE INSTALLING, BALANCING THE BLADES, OR CLEANING THE FAN. DO 
NOT INSERT FOREIGN OBJECTS BETWEEN ROTATING FAN BLADES.

NOISE

When it is quiet(especially at night) you may hear occasional small noises. This is normal. Please allow 
a 24-hou

r “

breaking-in

” p

eriod, most noises associated with a new fan disappear during the time.

CARE AND CLEANING

1.Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to 

avoid scratching the pain

t fi

nish. Please make sure to turn off electricity power before you clean your fan

2.Do not use water when cleaning your ceiling fan. It could damage the motor or the blades 

and create the possibility of an electrical shock.

3.Motor has permanently lubricated ball bearing. No need to oil

NOTE: MAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU 

ATTEMPT ANY CLEANING OR REPAIRS.

F4712110V

Installation & Operating Instructions for the

Parrotuncle Owner's Installation ,Manual

WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER