CAUTION
To comply with FCC RF Exposure requirements in section 1.1310
of the FCC Rules, antennas used with this device must be installed
to provide a separation distance of at least 20 cm from all persons to
satisfy RF exposure compliance.
DO NOT
- Operate the transmitter when someone is within 24 inches of
the antenna.
- Install antenna or mast assembly on a windy day
- Install the mast close to power lines as it can cause serious injuries
or death.
WARNING
This document gives the detailed instructions to install an antenna to
the best of our knowledge. This document if for general information
only. It cannot be used as a warranty. Parsec Technologies, Inc. will
not accept any liability for any damage caused by an antenna due to
unknown variables.
Make sure the fan cap covers are open while using the antenna.
Install the sim in router before mounting on to the router mount plate.
Warnings:
Step 7.
Step 8.
In the router, click on Status, Internet, and then Connections in the dropdown menu. You should see options related to
SIM cards installed. Select the option with a cellular SIM. (Figure 19)
If all of the steps are completed, the antenna should be on and operating. Close the top cover plate using the thread
forming screws provided in the kit. (Figure 20)
FIGURE 16
FIGURE 17
972-804-4600
Parsec Technologies
support@parsec-t.com
Last Revised: 3.9.2021
