Step 3.
Step 4.
Step 5.
Step 1.
Step 2.
Lift the antenna and remove the protective backing from the underside of the antenna and place the antenna back in
the desired position. Apply downward pressure on the antenna to stick it to the panel.
To avoid the gap between the antenna and panel, it is reccomenended to use neutral cure silicon sealant around the
base of the mounting boot to fully compress the antenna to the mounting panel.
A split flat washer and a split hex nut are provided in the kit for easy installation.
(Star washer is optional and not supplied.)
On the inside of the vehicle, thread the flat washer over the cable, followed by star washer (if applicable) and then hex
nut. (Figure 4 & 5)
Slide the washers and nut to the threaded flange of the antenna and tighten the hex nut until antenna compresses flat
with the surface of the vehicle.
(Figure 6)
Feed the coaxial cables from the antenna through the hole from the outside surface to the inside surface and thread
the entire length of the cable through the hole.
Clean debris off the vehicle surface and then mark the desired antenna orientation by placing the antenna flat on the
vehicle surface.
FIGURE 5
FIGURE 6
FIGURE 4
Roof
Split Washer
Split Hex Nut
Mounting the Antenna
*** For best performance avoid bending the cable under 0.5” radius. And make sure
the antenna is mounted in correct direction and tighten the mounting hardware. And
waterproof the RF connectors using electric tape or a heat shrink tube if required.
