7200 Monitor Instruction Manual
6 Basic Operational
6.1 Measure Mode
The normal operating mode for the 7200 Monitor is its measure mode and this is active when the measured value is
displayed in large numbers. Whilst in measure mode the display value is continually updated based upon the current
sensor input signal.
The display in measure mode also includes a status bar that scrolls through the status of the alarm and analogue
outputs and if the instrument is locked. The status bar is also used to indicate any instrument faults that are present.
During a clean cycle the status bar indicates the current stage of the clean cycle.
6.2 Measurement Cycle
The measurement cycle is carried out in the background at all times when the instrument is switched on regardless of
whether the instrument is in measure mode or not. It is therefore capable of updating the output signal and alarms
when the user is navigating the menu structure in order to change the instrument configuration. The monitor performs
five measurement cycles per second enabling a response time of one fifth of a second (Damping rate set to Instant –
see damping).
6.3 Display
The resolution of the displayed value is determined by the sensor range setting such that only sensible display values
are indicated, the same range also determines the calibration value range, alarm value range, and analogue output
range.
The display units and measurement title is user selectable and should be chosen to suit the parameter being
monitored and sensor being used.
167300IM-Issue 12 Issue Date 14/10/2014
Page 13 of 50
Measure Mode Display
Summary of Contents for 7200
Page 1: ...INSTRUCTION MANUAL 7200 Monitor Field Mount...
Page 2: ...This page is intentionally left blank...
Page 48: ...7200 Monitor Instruction Manual 167300IM Issue 12 Issue Date 14 10 2014 Page 48 of 50...
Page 49: ...7200 Monitor Instruction Manual 167300IM Issue 12 Issue Date 14 10 2014 Page 49 of 50...
