10
C H A P T E R 2 B I O S S E T U P
Entering the Setup Utility
When you power on the system, BIOS enters the Power-On Self Test (POST) routines. POST is a series of
built-in diagnostics performed by the BIOS. After the POST routines are completed, the following message
appears:
Press DEL to run Setup
Press the delete key <Delete> to access the BIOS Setup Utility:
BIOS navigation keys
The BIOS navigation keys are listed below.
Key
Function
← →
Moves between the available menus
↑ ↓
Moves the cursor between the displayed parameters
+ –
Modifies the selected field’s values
Enter
Go to sub screen
F1
Displays a general help screen
F2
Loads the previous values
F9
Loads the default configurations
F10
Saves the current configuration and exits Setup
Esc
Exits the current screen
Figure 3.1 Main BIOS screen
Summary of Contents for SP-600-A
