Bartendro
TM
B15
-6-
Step 3
Attach Wire Clips (optional)
We’ve included some adhesive wire
clips (I) to keep the power supply cable
neatly tucked behind the frame.
Use the alcohol pad to clean the
surface before you apply the clips so
that they stick well.
Remove the backing, and attach where
desired. You may use as many or as few
as you like.
I
Step 4
Plug in and Power On
Important:
Before plugging the power supply into your bot, make sure
the power switch is off. Plug the 4 pin connector into the bot first,
then plug the AC power cord into a wall outlet. Turn the switch on and
Bartendro will take approximately 1 minute to boot up.
Note: If the power supply experiences a fault while plugged in, its green light will
turn off. Reset by unplugging it from the wall and plugging back in.
Bartendro is ready when the dispenser’s lights begin to fade in and
out, changing color.
The status light on the right side of the bot will also turn green. This
light will also serve to notify you when ingredients are low or out when
the liquid sensors are enabled.
