Bartendro
TM
ShotBot
Cleaning and Maintenance
For longest tube life, you should clean all of Bartendro’s tubing after
every use.
Step 1
Get three tall glasses or containers. Fill one with hot soapy water, one
with clean water, and keep the third one empty.
Step 2
Go to
Admin > dispensers
, lift the flexible tubing out of the liquid or
bottle that it’s in and use the “turn on” button to drain the liquid from
the tubing into your empty glass.
Step 3
Place the drained tube in your container of hot soapy water and while
holding your empty glass under the spout, press the “clean” button.
The button is located at the bottom of
Admin > dispensers.
This will
run the dispenser long enough to wash out the tube.
Step 4
Repeat step 3 but with the glass of clean water. Sanitizing solutions
like Star San (beer brewing sanitizer) may also be used. Do not use
household chemicals.
Step 5
Finally, remove the tubes from the clean water and press the “clean” or
“turn on” button once more to empty the clean water from the tubing
and prepare it for its next use.
You should replace the inner beige Dispenser tubing after 500 hours
of use (actual rotation time). If you plan on not using the bot for over
one month, you should remove the beige tubing from the pump-head.
Instructions on doing this can be found at www.partyrobotics.com/
docs.
-10-
