F
E
Bartendro
TM
ShotBot
-5-
Step 3
Install Tubing and Spout
1)
Feed the rigid spout and flexible tubing
through the compression nuts. The end
with the angled cut goes into bottles and
the flat end towards the dispenser.
Make sure the tubing goes all the way
through the nut and sticks out by about
1/8” on the side that says “>PP<” on it. If
the opening in the compression nut is too
small, you can use the chopstick to widen
it.
2)
Attach the 2 inch, rigid spout on the
left side of ShotBot (E) and attach the
flexible tubing on the right (F).
3)
Tighten compression nuts so that there
are only one or two threads showing.
4) Feed the flexible tubing through the
opening in the metal (F).
