Bartendro
TM
ShotBot
-6-
Step 5
Attach Wire Clips (optional)
We’ve included some adhesive wire clips
to keep the power supply cable neatly
tucked next to the frame.
Use the alcohol pad to clean the surface
before you apply the clips (G) so that
they stick well. Remove the backing, and
attach where desired. You may use as
many or as few as you like.
G
Step 4
Insert SD Card
While looking at the back of ShotBot,
hold the SD card with the pins facing you
and carefully insert into the slot on the
back side of the Raspberry Pi board.
It will hang out a little bit. This is okay.
