®
M o d e l N o . P S - 2 1 0 0 A
I n t r o d u c t i o n
2
Introduction
The PASCO PS-2100A USB Link is an interface that uses the Universal Serial Bus protocol to enable communi-
cation between PASCO sensors and a USB-compatible computer that is running PASCO’s data acquisition soft-
ware*. The USB Link can be connected to and disconnected from a USB port without turning off the computer
first. If the USB Link is connected to a computer that is running the software, the light emitting diode (LED) on
the top of the USB Link lights up to indicate that the software detects the connection.
NOTE: If the computer is on, the data acquisition software is running, the USB Link is securely connected, but
the LED is not on, disconnect and then reconnect the USB Link to the USB port. (Contact Technical Support for
more information.)
*See the PASCO catalog or web site at www.pasco.com for more information.
The PS-2500 PASPORT Sensor Extension Cable is 2 meters long with an eight pin female DIN plug at one end
and a PASPORT sensor plug at the other end. Use the cable to extend the distance that your sensor can reach.
Technical Support
For assistance with any PASCO product, contact PASCO at:
For information about the USB Link, go to the PASCO web
site at www.pasco.com and enter PS-2100A in the Search
window.
Product End of Life Disposal Instructions:
This electronic product is subject to disposal and recycling regulations that vary by country and region. It is your
responsibility to recycle your electronic equipment per your local environmental laws and regulations to ensure that it
will be recycled in a manner that protects human health and the environment. To find out where you can drop off your
waste equipment for recycling, please contact your local waste recycle/disposal service, or the place where you pur-
chased the product.
The European Union WEEE (Waste Electronic and Electrical Equipment) symbol (to the right) and
on the product or its packaging indicates that this product
must not
be disposed of in a standard
waste container.
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Phone:
+1 916-786-3800 (worldwide)
800-772-8700 (U.S.)
Web:
www.pasco.com
Email:
support@pasco.com
•
SETUP:
For information on setting up the data acquisition software and recording data,
refer to the User’s Guide for the data acquisition software.
Limited Warranty
For a description of the product war-
ranty, see the PASCO catalog.
Copyright
The PASCO sci-
entific
Instruction Sheet
is copyrighted with all rights
reserved. Permission is granted to non-profit educational
institutions for reproduction of any part of this manual, pro-
viding the reproductions are used only in their laboratories
and classrooms, and are not sold for profit. Reproduction
under any other circumstances, without the written con-
sent of PASCO scientific, is prohibited.
Trademarks
PASCO, PASCO Capstone, and PASPORT are trade-
marks or registered trademarks of PASCO scientific, in the
United States and/or in other countries. For more informa-
tion visit www.pasco.com/legal.
