user manual
1.2 GENERAL SAFETY RULES
Before using the appliance, carefully read this use and maintenance manual in all its parts.
The installation and use of the product must be done in accordance with the manufacturer's
instructions, and in compliance with national and local regulations.
Installation, electrical connection, validation, maintenance and repairs are operations that must be
carried out exclusively by qualified, authorized personnel with adequate knowledge of the product.
The installation of the product must not be carried out close to wooden walls or flammable material,
isolate the stove from the floor if this is made up of flammable materials, keep a safety distance of at
least 20-30 cm from flammable or heat-sensitive materials (beaded walls, wallpaper, sofas, etc.) .
Do not embed the stove in confined spaces or place it adhering to the walls
The appliance must be connected to a system equipped with a PE earth conductor (in accordance
with the provisions of the regulations relating to low voltage equipment). Before installing the
equipment, it is necessary to check the efficiency of the ground circuit of the power supply system.In
the presence of high electrical absorption peaks or in areas with irregular supply of electricity, it is
advisable to combine the machine with an uninterruptible power supply to avoid voltage drops.
During operation, the flue gas pipes, the glass, the door, the handles and some parts of the
appliance can reach very high temperatures: be careful not to touch them. The absence of the
correct draft of the flue (obstruction of the same or of the air intake pipe, presence of residual
material in the brazier that obstructs the holes) alters the functioning of the stove which in the
ignition phase leads to an excessive dosage of fuel in the brazier. If you notice an abundant
stagnation of the fumes inside the combustion chamber, immediately move away from the
appliance. The excessive concentration of smoke could create a deflagration that could break the
glass. Do not open the door and move away from the appliance until there is smoke. Do not
unplug the electrical socket.
Thoroughly clean the stove, the suction duct and the flue. In the presence of some malfunctions,
the fuel supply is cut off by the safety device. Please, restart the appliance only after eliminating the
cause of the fault. Suspend use of the product in the event of a breakdown or malfunction and
contact technical assistance.
It is absolutely forbidden to use any type of fuel (liquid, solid ...) to ignite the stove: ignition must
take place automatically as foreseen and indicated in this installation, use and maintenance.
Do not pour pellets (or other materials) directly into the brazier. Do not store non-heat-resistant,
flammable or combustible objects near the appliance: and keep them at an adequate distance. Do
not use the product as a support for drying clothes. It is forbidden to open the door during operation,
or to operate the stove with broken glass.
The stove must not be used by children or unassisted disabled persons without assistance.
Do not touch the stove when you are barefoot or when parts of the body are wet or humid.
The safety and adjustment devices must not be modified without the authorisation or
indications of the productor.
2
Summary of Contents for SOFIA
