9
Battery and Charging System
Inserting Battery
1.
Load the battery, contacts first, into the Cordless
Framing Nailer.
2.
Push battery fully forward into its locked position.
3.
To remove battery, push down on locking tab and slide
battery out.
Battery Indicator Light
The illustration is a close-up of the side of the Paslode
Cordless framer handle. On the side of the handle is a small
plastic lens. This is the battery indicator light.
When you insert a fully-charged battery into the tool, you will
see a blinking green light. If the light blinks red, recharge the
battery.
Battery
Indicator
Light
Battery Standby
The battery can be placed in the standby position if the
tool is not going to be used for a period of time.
To place the battery into the standby position, push down
on the locking tab and slide the battery back so that the
locking tab engages into the standby position in the handle.
NOTE:If battery is left in tool for an extended period of time
in the normal operating position, the battery will discharge
completely and will require recharging.
Locking Tab
Standby Position
Normal Operating Position
