Loading Coil Nails
Step No. 1 – Grasp the nailer handle firmly with one
hand and with the other hand unlatch the magazine
cover clip. Swing the magazine door open.
Step No. 3 – Remove the band from a nail coil
and
place the nail coil in the magazine with the tips of the
nails against the loading tray and with about 4 inches
of coil unwound. Make sure the coil is centered over
the post.
Step No. 4 - Slide the free strip of nails along the top of
the feeder body assembly and place the first nail in the
nose of the tool with the head of the nail on the magnet.
Step No. 5 - Carefully close and latch the magazine door.
Step No. 6 - The nailer is now ready for use.
12
Fasteners
The Paslode Cordless Roofing Nailer drives Paslode
Roofing
®
coil nails designed to be used with the tool.
The use of fasteners that do not meet Paslode stan-
dards could cause tool damage and will void all war-
ranty
claims.
Preparing the Cordless Roofing Nailer for Use
Step No. 2 – Adjust the nail tray to the proper
position by depressing the button on the post and
rasing or lowering the tray. For 7/8” to 1 1/2” nails
set the tray to the upper position. For 1 3/4”nails,
set the tray to the lower position. Nails will not feed
into the nose of the tool if the tray is set in the wrong
position.
