Paslode Cordless 16 Gauge Angled
Lithium-ion Finish Nailer Operation
14
Depth of Drive Adjustment
Remove the battery before adjusting the depth of
drive.
The depth of drive adjustment is done by turning the
adjustment wheel as shown by the arrows on the side of
the tool.
Cold Weather Operation: (Continued)
DANGER
CAUTION
This tool must be operated in a well ventilated environ-
ment, because the tool exhausts carbon monoxide
similar to a chainsaw or lawn mower. Exposure to
carbon monoxide may cause dizziness, nausea or
unconsciousness.
It will be necessary to repeat this procedure several
to operate in it’s normal mode.
times until the temperature of the tool warms up enough
Once the tool reaches operational temperature the tool
will generate it’s own heat and will function normally.
If the tool sits for an for an extended period of time and
cools down it may be necessary to repeat these steps.
CAUTION
The Cordless Finish Nailer should not be used
in the rain or where excessive moisture is present.
The use of the Paslode Cordless Technology under
these conditions may result in damage to tool
components and cause the tool to malfunction.
®
WARNING
During the warm-up process, never expose the
tool, fuel cartridge, or battery to flame.
The No Mar Probe and nose will become hot after
prolonged or rapid use. If it becomes necessary to
adjust the No Mar Probe, avoid touching with bare
hands.
PRESS NO MAR
PROBE AGAINST
THE WORK
SURFACE.
Fan motor starts,
fuel is injected into
combustion cham-
ber and mixed with
air by the fan.
SQUEZE TRIGGER
Spark plug ignites
the fuel/air mixture,
driving the piston
assembly down on
the fastener.
RELEASE TRIGGER
- LIFT TOOL
Combustion
chamber opens.
Fan exhausts,
cooling internal
components.
INCREASE
DEPTH OF DRIVE
Counter
Sunk
Proud
DECREASE
DEPTH OF DRIVE
