6
Precision Placement Driving
■
Grasp the tool handle firmly and place the bottom of the work
contacting element firmly against the workpiece until it is com-
pletely depressed.
■
Squeeze the trigger to drive the fastener.
■
Lift the tool from the workpiece.
■
Repeat the procedure for the next fastener.
Successive (Bounce) Driving
■
Grasp the handle firmly.
■
Squeeze the trigger and move the tool along the workpiece
with a bouncing motion, depressing the work contacting element
at the points where you want to insert a fastener.
■
Keep the trigger depressed and continue to bounce the work
contacing element against the workpiece, positioning the tool
above as carefully as possible.
■
When the desired number of fasteners have been driven,
release the tool trigger to avoid unintentional fastener discharge.
TOOL OPERATION -
continued
Loading of Nails
Step 1 - Grasp the handle firmly.
Step 2 - Insert one or two strips of nails into the
rear of the magazine.
Step 3 - Pull the follower to the rear of the
magazine until it is engaged behind the
nails.
The tool is manufactured with a (Silver) sequential
trigger installed.
Sequential Operation
-
(Silver
Trigger)
The sequential operating trigger prevents successive
or “bounce” driving.
■
Depress the work contacting element and hold it
against the work surface before pulling the trigger.
■
After each fastener is driven, completely release
the trigger and lift the tool from the work surface.
Grommet
Trigger Pin
Sequential Lever
Sequential
Trigger
Sequential
Actuator
#501039
Contact Trip (Bounce) Trigger Operation-
(Orange Trigger)
Grommet
Trigger Pin
Bottom Trip Lever
Contact
Trigger
The
trigger
kit
(#501048)
allows
successive
or
“bounce”
driving.
#501048
WARNING
Do not clamp or hold the trigger with
anything other than your hand.
