TOOL OPERATION
Trigger Methods:
The Paslode T250S-F16 Finish Nailer has a triggering
system than can be switched from sequential to contact
trip. To switch the trigger, press in the round orange
button on the right side of the trigger and rotate the left
side of the button to the desired triggering method. The
TTT indicates contact trip and the T indicates sequential
operation.
Successive (Bounce) Driving -
Grasp the handle firmly.
Squeeze the trigger and move the tool along the
workpiece with a bouncing motion, depressing the work
contacting element at the points where you want to drive
a fastener.
Keep the trigger depressed and continue to bounce the
work contacing element against the workpiece, position-
ing the tool above as carefully as possible.
When the desired number of fasteners have been
driven, release the tool trigger to avoid unintentional
fastener discharge.
6
Reversible Belt Hook:
The belt hook can be changed from the left hand side of
the tool to the right hand side. To change the position,
squeeze the base of the belt hook and remove it from the
tool and position it on the desired side.
Adjustable Exhaust:
The direction of the exhaust air can be changed by
rotating the orange air deflector on the cap of the tool.
Sequential Operation -
The sequential setting T prevents succesive or "bounce"
driving.
Depress the work contacting element and hold it
against the work surface before pulling the trigger.
After each fastener is driven, completely release the
trigger and lift the tool from the work surface.
➔
➔
➔
➔
