If the Output Switch Linked mode is set with Link = OFF, the User can “Manually” Load one of the 10 switch
Presets available and previously created using the Pc Sw.
This can be done from the Out Switch Setup Menu
Within this Menu, the User can select and Load one of the 10 available Switch Presets.
Pressing the Button 1 / Enter, the following sub-menu is entered:
Here, the user can recall one of the 10 available Switch Presets SP01-SP10, just selecting the
desired one by the Up/Down buttons.
As said, in this way any action on the Preset Buttons, forcing the Load of the corresponding Audio Preset, will
not affect the status of the Output Switches, which will depend from the Preset loaded “Manually” by the User
within the Output Switch Setup, being the Output Switch Linked Status set as OFF.
In order to finally leave and exit the System Setup mode, so to get back to normal working mode, is is enough
to get back to any one of the 5 System Setup Menus and there from press the ESC button.
NOTE
: The All Settings done within the System Setup Function will be effective ONLY WHEN LEFT the System
Setup Mode itself.
Within the System Setup Mode, the all communications with the remote control units are DISABLED, so as the
some “Real Time” processes available in the DMX8008.
In Stand Alone Mode, the “Activity” of the DMX8008 in terms of running processes and signal status, per each
channel, can be checked thanks to the Vu-Metering features:
1 led for Microphone Phantom Power Supply Active
5 led for Outputs Activities:
System Setup
----- Out Switch Setup -----
OUTPUT SWITCH SETUP
SP01
10
DMX 8008
