0
4.2 Priority
To set the priority of a station, it is necessary to
press the keys ALERT, EVAC and RESET/ACK simultaneously for more
than 3 seconds
. When the
RUN/SET
LED stops flashing and remains steady ON, release the keys.
There are seven
priority levels at disposal (from 8 = lowest priority to 14 = highest priority)
.
PRIORITY
10
11
1
1
1
LED
If you do NOT want to save the changes made, simply wait for the timeout (about 10 seconds), after which the previous
settings will be restored.
Note
:
The priority level set determines the operational status both in emergencies and in broadcasting conditions
.
On pressing the
ALERT
key, the LEDs will indicate the current priority setting (
default factory setting: 8
).
To change the priority, hold the
ALERT
key down and press
AUX
(to increase the number) or
P.T.T.
(to decrease it).
The LEDs corresponding to each priority level are shown in the following table.
To leave the settings mode and save the changes made, press the
ALERT
,
EVAC
and
RESET/ACK
keys again: the
RUN/SET
LED will start flashing again.
