January 2021
50
Pathport® OCTO - 64XX - Manual
SETTING SECURITY MODE
When the device boots up for the first time, or if it has been Factory Defaulted or had its Security Settings reset, the Security
Mode screen will be shown.
Security Mode
Wait for Pathscape to Secure
Local Configuration Only
Disable Security
Before you can configure and use the device, you must either:
• Use Pathscape to Secure the device
(Add it to a Security Domain).
No input from the front panel is required
here
. Clicking the encoder knob to select
Wait for Pathscape to Secure
will show the device Serial Number and MAC
Address, in cases where this may be helpful for device identification
Wait for Pathscape to Secure
Serial # : PPXXXXXXX
MAC : XX:XX:XX:XX:XX:XX
<Back>
• Enable
Local Configuration Only
(Read only) mode. Turn the encoder to select
Local Configuration Only
. In the
submenu, confirm by selecting
Local Configuration Only
again. You will then have full access to the menus.
Security Mode
Wait for Pathscape to Secure
Local Configuration Only
Disable Security
Local Configuration Only
Cancel
Local Configuration Only
In Local Configuration / Read Only mode,
Pathway ssACN
(Secure sACN) is not available. To use other standard
(unsecured) protocols, you
must manually enable them
(see below). As explained above, you cannot use Pathscape
to configure the device in this mode.
Summary of Contents for Pathport OCTO 64 Series
Page 7: ......
