©
AEI CORPORATION 2005
12
Step 2 A:
Slide 3” Vinyl sleeve down post.
Align the holes in the socket with
the post and vinyl sleeve. Insert lock
washer, flat washer, and screw into
four holes. (See Figure #2 A)
Step 2 B.
Securely tighten the four stainless
steel screws with flat washers and
lock washers (lock washer is
installed first against post and then
flat washer) at post to socket
connection. (See Figure #2 B)
Figure 2A
Figure #2B
Step 3:
Slide 3” diameter stainless steel
slip collar over post. The slip collar
should now be at the bottom of the
post/socket assembly. The slip
collar is intended to cover the
fasteners and vinyl sleeve.
(See Figure #3)
Figure #3
Step 4:
Side decorative cover down the post
over slip collar. Be careful, this
piece has relatively sharp metal
edges.
(See Figure #4)
Figure #4
Summary of Contents for NPC05
Page 8: ...AEI CORPORATION 2005 8...