Wireless Data Acquisition System Instruction Manual
54
(3)
Install, Initialize, and Change Settings Functions
①
Display Communication Quality
You can use this product's display status indicator to determine the wireless communication status.
The indicator operates as follows.
Indicator Light
Wireless Connection Status
Green pulse
Indicates a good status.
This status indicates the product can communicate directly with the WDR without
relying on other WDT.
(If the WDT and WDR are close together (within tens of centimeters), WDT may
display a red pulse.
For an accurate display, use the units with a separation of about 1 m.)
Amber pulse
Direct wireless connection with the WDR is not good, but the connection with nearby
WDT is good.
If nearby WDT have a green pulse, the WDT will be used as a repeater for
communication.
Red pulse
Connection is not good with any WDR or WDT in the WD wireless network.
Red light
Product is waiting to join the WD Network.
Pulse is where the lamp fades between bright and dark repeatedly.
When the indicator light displays something other than the above, refer to
☞
②
Display WDT Call
When the device receives a specific command from the host PC, the WDT indicator flashes blue for approximately
10 seconds. Display is also possible with a WDS-WIN01 operation.
③
Periodic Transmission
By setting DIP switch 4 ON, the WDT transmits the current signal tower status every 10 seconds.
If the frequency of signal tower information is low (a few times per hour), you can use this function so communication is more
stable than when using immediate transmission mode.
④
Initialization
Use this switch to reset all the settings in the main unit to their initial state. Initialized items and their initial settings are as
follows.
