Wireless Data Acquisition System Instruction Manual
27
(1-4) WDR Installation Position and Obstacles
When installing onto a pillar such as the I-beam in a building, install the WDR in a direction that promotes the propagation of
radio waves.
When storing the WDR in a box, use a resin box with radio wave permeability.
(2)
About the Signal Tower Power Supply status
To operate the WDT, you need to
constantly supply power
to the LR series signal tower's power line.
For more information, refer to
☞
"7.1 Wiring".
6.3 Equipment Settings
This section describes the steps for setting up and installing equipment. Refer to
☞
"7 Operation" as well as instruction
manuals of related products.
(1)
Setup Information
Have the information for the settings below prepared beforehand.
Information required
Description
Information about the
equipment to connect
Equipment name and other identifiable equipment information
Information about the
target Signal Tower
Model, power supply specifications, operation information
WDT and WDR
common settings
Wireless settings
ExtendedPanID
Refer to
☞
Wireless channels
Refer to
☞
WDT settings
Run time settings
Determine Signal
Tower Input
Refer to
☞
Power supply settings
*1
Simple counter function
Refer to
☞
the signal wire for a simple
counter"
Transmission mode
Refer to
☞
Related to Wireless Data
Transmission"
WDR settings
Wireless settings
Network startup method
*2
LAN communication
IP address
*3
Subnet mask
–
Default gateway
DNS server port number
–
