Collar Fitting
Please fit the collar properly so that the Contact Points press firmly
against the dog’s skin. When properly fitted, you should be able to put
a finger in between the Receiver Collar and dog’s neck.
Caution:
1.do not shave the pet’s neck as this
may increase the risk of skin irritation.
2.the collar should not be worn for more than 12
hours per day. Or it may cause skin irritation.
Too tight:
it may cause dog’s to breathe hard.
Too loose:
the Receiver Collar will move around the dog’s neck, the
Contact Points may hurt the dog’s skin.
3. Press the Shock Button and the Test Lamp will be lighted. It will be
Use the Test Lamp to tighten or loosen the Contact Points when
prepare the Receiver Collar.
As a Screw Driver
Pair the Remote and the Receiver Collar
1. Use the switch on the Remote to select Dog 1 .
2. With the Remote turned on and the Receiver Collar turned off, press
and hold the ON/OFF Button on the Receiver Collar for 4-5 seconds.
3. The Red & Green LED will blink for about 10 seconds indicating that
it is ready for pairing.
4. Press and hold Tone Button and Vibration Button at the same time
for 2-3 seconds, the Green Led on the Receiver Collar will blink
for 5 times indicating successful pairing.
1. Use the Button on the Remote to select Dog 2. Then follow
the above pairing steps from 2-4.
Dog Training
Find the Best Shock Level for Your Pet
Device Information
Battery Type
Battery Life(typical use)
Remote Waterproof Rating
Receiver Waterproof Rating
Operating temperature range
Wireless Power
Wireless Range
Product Specification
IEC 60529 IPX7, waterproof
20dBm(100mW)
300m(984 feet)
From 0-40
℃
(from 32-104
℉
)
Non-Waterproof(Keep away from water)
Remote: 27 days
Receiver: 11 days
Rechargeable, lithium polymer battery
lighter accordingly with the Shock Level increasing.
8
9
10
11
12
13
How long can I
continuously deliver
Vibration/Shock to
my pet?
The maximum amount of time you can press
the Vibration/Shock Button and deliver
Vibration/Shock to your pet continuously is
10 seconds. After this, there’s a time-out an
Vibration/Shock cannot be delivered for 5
seconds. After the 5 second time-out period,
Button can be pressed and Vibration/Shock
can be delivered again.
Troubleshooting Guide
Make sure the Receiver Collar has been turned on.
If your range has reduced from the first time you
used the Remote Training Collar, the battery(s)
may be low in either the Remote or Receiver Collar.
My pet does not
respond when I
press a button.
The Receiver
Collar will not
turn on.
Make sure the Receiver Collar is on.
If the Indicator Light does not come on when any
button is pressed on the remote, ensure that the
batteries are charged properly.
If the first two solutions did not resolve your problem,
Refer to
.
“Pair the Remote and the Receiver Collar”
Make sure the Receiver Collar has been charged.
For the initial charge, be sure to charge it for 4
hours. Subsequent charges only take 2-3 hours.
Terrain, weather, vegetation, transmission from
other radio devices and many other factors can
impact the amount of range you have with the unit.
Test the Receiver Collar. Refer to “How to use the
Test Lamp” for details.
Increase the Shock Level. Refer to “Find the Best
Shock Level for Your Pet” for more information.
Make sure the Receiver Collar’s Contact Points
are placed snugly against your pet’s skin. Refer to
“
Collar Fitting” for more information.
The Receiver
Collar is not
responding to
the Remote.
Others
Frequently Asked Questions
Will I get exactly 984 feet
of range with the Remote
Training Collar?
Is the Vibration/Shock
safe for my pet?
How old does my pet have
to be before using the
Remote Training Collar?
Once my pet is trained and
has been obeying my
commands, will he have to
continue to wear the
Receiver Collar?
Is the Receiver Collar
waterproof?
While the Vibration/Shock is unpleasant,
it is harmless to your
pet. Electronic
training devices require interaction and
training from the owner to achieve
desired results.
Your pet should be able to recognize
basic obedience commands such as
“Sit” or “Stay”.Pets should be at least 6
months old before using the Training
Collar.
Probably not. You may need to reinforce
training with the Receiver Collar from
time to time.
Yes.
The range of the Remote Training will
vary according to terrain, weather,
vegetation, as well as transmission
from other radio devices. Refer to “To
maximize the distance” for tips on
maximizing your range.
The unit comes with Up and Down buttons to control the Shock Level,
with Level 1 being the lowest level and Level 16 being the highest. The
level of Shock best suited for your dog depends on your dog’s
temperament and threshold for Shock. Always start at the lowest level
and work your way up.
The appropriate level can be found when the dog
responds to the Shock with a mild reaction,
such as a flick of the ear, a
lick of the lips, a tensing of the neck muscles etc. The Shock Level may
vary depending on the training situation.
When highly distracted, dog’s
will require a higher level of Shock.
The unit need to be charged under any of below situations
1. The indicator light on the Receiver Collar is emitting a red color every
seconds or flashes rapidly.
4
2. The 3 bar indicator on the Remote LCD shows just 1 bar.
3. The indicator light on the Remote or Receiver Collar will not come on.
4. The indicator light on the Remote or Receiver Collar comes on
momentarily when any of the Mode Buttons is pressed.
Pairing a Second Collar with the Remote
Warranty and repair information
1-Year Limited Lifetime Warranty
The original purchaser for this unit is provided with 1-
YEAR
WARRANTY
.
The warranty begins from the date of purchase. For the first year,
coverage is for both Parts and Labor on warranty repair services.
Accessories such as straps and batteries are covered for the first year
only. After the first year, the Limited Lifetime Warranty covers Parts
only and does not cover Labor Fees and Accessories. All shipping fees
incurred, the cost of Accessories after the first year, and Labor fees
associated with out of warranty repair work, are the customer’s
responsibility. Labor fees will be variable depending on the extent of
the work required. The Limited Lifetime Warranty expires 5 years after
a model is discontinued from production.
To Qualify for the Warranty
All products must provided a proof of purchase is required to initiate
repair work under warranty. We strongly recommend keeping the
original receipt. If a proof of purchase is not available at the time of
service, we will estimate the age of unit by the serial number. Serial
number estimates can differ from the actual purchase date. A serial
number estimate is the only method of determining an approximate
date of purchase without a proof of purchase.
Not Covered Under Warranty
We DO NOT offer warranty for products that have been bought
secondhand or as a resold product. We DO NOT replace defective
units or provide refunds for products purchased from us after 30 days
from the date of purchase. Issues of replacement and refunds on units
purchased less than 30 days from an authorized dealer must be
addressed to the dealer directly. If the products purchased from an
authorized dealer are after 30 days from the date of purchase, please
send the units to us for service and repair. We DO NOT cover the cost of
repairs and replacements due to misuse by the owner or dog, improper
maintenance, and/or lost units. Any water damage on the Water
Resistant remote and the Water Resistant Receiver of our product
Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
Procedure for Repair Work
series will not be covered. All replacement costs for either the remote
or receiver will be the owner’s responsibility. The warranty is void if the
unit has been altered or an unauthorized person has damaged the unit
while attempting repair work. We reserve the right to retain and discard
any parts or accessories that have been found damaged upon
replacement and repair.
If the unit is malfunctioning, please refer to the “Troubleshooting
Guide” in the quick start before sending it back for Service. The cost of
shipping products under warranty back is the customer’s responsibility.
We are not responsible for units damaged or lost in transition. We are
not responsible for loss of training time or inconvenience while the unit
is in for repair work. We do not provide loaner units or any form of
compensation during the repair period. A copy of the sales receipt
showing the purchase date may be required before warranty work is
initiated. Please include a brief explanation outlining the problem and
include your name, address, city/state/zip code, daytime phone
number, evening phone number, and email address.
Compliance
FCC - USA
This device complies with part 15 of the FCC Rules. Operation is
subjectto the following two conditions:
(1) This device may not cause harmful interference.
(2) this device must accept any interference received, including
interference that may cause undesired operation.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
CAUTION: Modification or changes to this equipment not expressly
approved by manufacturer
may void the user”s
authority to operate the equipment.
Selecting The Contact Points and The Contact
spring sheet
For the best results, select the correct Contact Points based on your
dog’s coat.
You can use the Contact point separately,
or use the Contact point and spring at the same time.
04
RoHS
MADE IN CHINA
Shenzhen Patpet Technology Co.,Ltd
Add: No.1 Qinhui Road, Gushu Community,
Xixiang Street, Baoan District, Shenzhen, China
The R&D of Dog Remote Training Collar
https://patpet.com/
support@patpet.com
@PatpetDogCollar
8
9
10
11
12
13
14
