Page 3 of 6
ASSEMBLY INSTRUCTIONS (continued)
The Position of Control Panel
Sensor
221116
Turn on the power at fuse or circuit box.
5. Install the bulb (not included).
See relamping label at socket
area or packaging for
maximum wattage allowed.
3. Pull out the source wires from
the outlet box. Make wire
connections using wire
connectors (CC) as follows:
• Connect the hot wire (black
insulation) from the fixture to
the black wire from the power
source.
• Connect the neutral wire
(white insulation) from the fixture to the white wire
from the power source.
• Attach the fixture ground wire (bare wire) to the
crossbar unit (AA) with the green ground screw,
then depending on local code, connect it to the
house ground wire with the wire connector (CC).
Carefully put all of the wires back into the outlet box.
3
Green Ground Screw
CC
AA
4. Attach the backplate (A) of the
fixture to the crossbar unit (AA) by
aligning and inserting the two
fixture mounting screws from the
crossbar unit (AA) into the open
holes on the backplate (A), then
place the two rubber pads (EE)
over the exposed fixture mounting
screws before screwing the two
bolt nuts (DD) on to screws.
Note: With silicone caulk compound, caulk
completely around where the backplate meets with
the wall surface to prevent water from seeping into
the outlet box.
A
AA
DD
EE
4
Max.60W Type A Bulb
(not included)
5
Sensor
Fig.1
Fig.2
View Fig.A
Fig.3
Step 1: Rotate the sensor clockwise or counter-clockwise
at maximum 90 degree to show the adjustable
knobs. (See Fig.1)
Step 2: Adjust time and sensitivity, choose the mode you
want by turning the knob. (See Fig.2 and Fig.A).
Step 3: Restore the sensor to original position by rotating
to the opposite direction. (See Fig.3)
Fig.A
"Time" Knob
"Mode" Knob
"Sens" Knob
Small Screwdriver
(not included)
Fig.A
Time
Mode
Sens
Auto
Test
PC
Fixture
Mounting
Screw
