09 Adjusting and Balancing blades
On the blade that the least wobbling is seen
with the balancing clip, slide the clip away
from the center of the blade in small
increments, run the fan, and slide it again
until the wobbling is elimited as much as
possible.
Run the fan to check for wobbling. If wobbling
exists, turn off the fan, put the balancing clip
halfway on a blade and check again. If the
wobbling persists, repeat the above with
Stick the adhesive-backed balancing weight
to where the clip stops. Add more weight if
needed for the fan to run smoothly.
another blade.
Summary of Contents for SO13
