7
CARE AND MAINTENANCE
WARNING: Make sure the power is off before cleaning
your fan.
Because of the fan’s natural movement, some connections may become loose. Check the support connections,
brackets, and blade attachments twice a year. Make sure they are secure. It is not necessary to remove the fan
from the ceiling.
Clean your fan periodically to help maintain its new appearance over the years. Do not use water when cleaning,
as this could damage the motor, or possibly cause an electrcal shock. Use only a soft brush or lint-free cloth to
avoid scratching the finish. The plating is sealed with a lacquer to minimize discoloration or tarnishing.
You do not need to oil your fan. The motor has permanently-lubricated sealed ball bearings.
Always unplug the fan before cleaning, disassembly or servicing.
TROUBLESHOOTING
Check the main and branch circuit fuses or breakers.
Check the line wire connections to the fan and switch wire connections in the switch housing.
Check the battery in the remote control.
Ensure you are in the normal range of 10-20 feet.
Turn the power off and ensure that the dip switch settings are the same on the remote control
and receiver.
Ensure all motor housing screws are snug.
Ensure the screws that attach the fan blade bracket to the motor hub are tight.
Ensure the wire nut connections are not rattling against each other or the interior wall of the
switch housing.
Allow a 24-hour “breaking in” period. Most noises associated with a new fan disappear during
this time.
If you are using the Ceiling Fan light kit, ensure the screws securing the glassware are tight.
Check that the light bulbs are also secure.
Ensure the canopy is a short distance from the ceiling. It should not touch the ceiling.
Ensure your outlet box is secure and rubber isolator pads were used between the mounting
plate and outlet box.
Check that all blade and blade arm screws are secure.
Most fan wobble problems are caused when blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip of one of the blades. Measure from a point on
the center of the blade to the point on the ceiling. Rotate the fan until the next blade is
positioned for measurement, and measure from the same point on each blade to the ceiling.
Repeat for each blade. Any measurement deviation should be within 1/8 in. Run the fan for ten
minutes. If the fan continues to wobble please contact Patriot Lighting Customer Service and a
balancing kit will be sent to you at no charge.
Problem
Solution
The fan will not
start
The fan is noisy
The fan wobbles
1
2
4
6
10
11
5
8
7
9
Transmitter
1.Pilot switch
2.Light ON
3.Light OFF
3
4.d
5.dimming -
6.light tempe
7.light temperature -
8.light temperature
9.Fan gear: Low /Mid /High
10.Timing function: 1H / 2H
11.Fan stop
Questions, problems, missing parts?
Before returning to your retailer, call our customer service
department at 1-833-695-2045, 8:30 a.m. - 5 p.m., EST, Monday - Friday.
