9
6
Mount Assembly
1. Place the pre-assembled Az-El pole mount on top of the 6 5/8” OD pipe, leaving the bolts
loose.
2. Add nuts and washers from the A
z-El Elevation
pack hardware to the Threaded Elevation
Rod as shown. Thread the nut all the way up to the welded end. Insert the rod into the
Anchor Block pre-assembled on the Az-El pole mount.
3. With 2 helpers place the hub assembly in the zenith (bird bath) position on top of the Az-El
mount as shown. Insert bolts and washers to hold the hub assembly to the mount cross bar.
Assemble the Threaded Elevation Rod to the hub extension as shown using pre-installed 3/4”
hardware.
NOTE: You must position
the hub in the position
shown below or it will be
unsafe to build the reflec-
tor. You will also be able
to assemble the dish with
out moving your ladder.
With the mount pipe bolts
loose the dish can spin on
the pipe for ease of assem-
bly.
Hub
Az-El
mount
29”
Elev.
Rod
224115
28001
28002
Pivot Block
21104G
Summary of Contents for 2.4m Offset Antenna
Page 1: ...2 4m Offset Antenna Receive only and Transmit Receive...
Page 19: ......
