SETTING UP
Warning! Risk of injury!
Before performing any operation unplug the power cord from
the wall socket.
Auxiliary handle
(see Picture
C)
Always use the hammer
with the handle
(
2
)
attached. The handle provides additional support and safety
during use. It is suitable for both right
-
and left
-
handed people.
•
Put the collar (c1) onto the hammer neck and insert the nut piece (c2) into both slots in the collar.
•
Put the holder (c3) onto the threaded end of the handle (c4)
and drive the handle thread into the nut
piece (c2).
•
Tighten the handle (c4) by turning it clockwise.
Information on the tools
(see Picture A)
The machine is designed for using replacement chiseling tools
with
SDS-
max
shaft
.
Always use a tool
suitable for the material being worked.
Warning! Risk of injury!
When replacing
the
tool,
wear protective gloves.
The tool
and
chuck may become hot during use.
SDS tool inserting and removing
The power tool is equipped with SDS
-
max
chuck which enables quick and easy tool replacement.
•
Clean the tool shaft and grease it with special
lubricant for SDS tools
.
•
Pull back the chuck collar
(1)
and insert the
tool.
•
Release the collar, this locks the tool holder. Pull the tool to ensure that it is locked in place.
•
To remove the tool, pull back the chuck
collar (
1
) and take out the tool.
Gearbox lubrication
Check before each use if there is enough lubricant in the machine
gearbox
.
Hold the hammer in normal
working position and use the wrench (5) to remove the oil cover (4). If needed, fill in the necessary
amount of
gearbox lubricant
suitable for electric tools. The lubricant
can be obtained from a professional
tool shop.
28