O
PERATION
Personal protective equipment
•
Wear protective gloves.
•
Wear protective goggles
.
Flying debris can cause injury
.
•
Wear hearing protection for protection from continuous noise in the work place.
•
Wear dust mask for protection from airborne dust.
Check whether the type of the plug corresponds with the type of the socket
.
The data on the nameplate must correspond with the actual power supply voltage.
Warning! Risk of injury!
Make sure that the On/Off switch (
8
) is not pressed down or
locked by the setting button (7).
Pay attention when working that the air vents are not
covered up or congested.
Switching on
Press the switch (
8
) and hold it
.
Switching off
Release the switch
(
8
).
Switching permanent run on
Press the switch (
8
) fully, push the locking button (
7
)
and release the switch
.
This will lock the switch and
keep the machine running
.
Switching permanent run off
Press the
switch (
8
)
again
and release it
.
The machine will stop
.
Warning! Risk of injury!
Should the power tool fall out of your hand during permanent
operation, it will not be automatically switched off.
In this case, immediately pull out
the power plug from the power outlet
to safely switch the tool off.
Note:
The hammer is equipped with a shock absorber (6) which reduces the vibration on the handle
(9)
when operating.
Working instructions:
•
Always choose the correct type and shape of chisel tool
for the worked material.
•
Before inserting SDS tool always grease its shaft with special SDS lubricant
.
•
Avoid overheating of tools
by letting them cool down during stops.
•
If the chiseling
tool gets stuck in the material, do not force it out by wobbling the hammer as this
may damage the chuck. Remove
the tool from chuck and then release it from the material.
29