14
With a helper place the center plate in place in the center of the opening of the panels using
hardware from
Center Plate
pack. From behind place the back brace through the hub center
across the hub opening. Tighten the nut on the bolt being careful not to overtighten which could
crush the petals.
NOTE: If you need to climb into the dish be sure to place your feet along the Radial Beams and
not into the center areas of a panel!
Center
Plate
The antenna assembly is now complete. Now lower the antenna out of the “bird bath”
position. To adjust the antenna toward the selected satellite you must
fi
rst know its elevation
angle above horizon. This will be the reference angle for the face of the antenna. Using an
inclinometer on the face of the antenna pre-adjust the desired angle Tighten the Az-El pipe
head bolts only enough to allow rotation of the mount on the ground pipe. Knowing the azi-
muth angle of the satellite from due south roughly aim the antenna in that direction. With the
LNB connected to the proper sight-in equipment the antenna can be accurately adjusted to the
satellite signal. Tighten all hardware.
Installation is complete.
