9
1. Place the King Post assembly onto the foundation sliding the bottom plate on to the threaded studs point-
ing the “A-frame” assembly of the mount in the desired direction- south in the northern hemisphere, north in
the southern hemisphere. (see Note on page 4 regarding stud installation).
Tighten the nuts so that the square tube mast is relatively plumb. (Make sure to use base plate
washers as pictured below.)
2. Assemble the Azimuth Lock down threaded rod to the main post clevis double nutting it with the pre-as-
sembled washers and nuts. Attach the thru-hole end to the A-frame attachment details. Snug the Lock down
bar hardware so the Hub assembly can be safely placed.
3. With 2 helpers place the Hub assembly in the zenith (bird bath) position on top of the King Post A-frame
as shown using the preassembled hardware in place on the A-frame. (Note the position of the Elevation
detail!)
4. Assemble the elevation Turnbuckle as shown, and adjust
it to position the Hub assembly in the upward “bird bath”
position.
NOTE: Attach turnbuckle to either the higheror lower at-
tachment based on your elevation requirements.
Mount Assembly- Fixed
