USING CLEANING AGENT
Read carefully the
instructions and warnings on the labels of the detergents used and store them in a
safe place out of children‘s reach.
In the event of contact with the eyes, wash immediately with water. If swallowed, do not induce
vomiting: consult a doctor immediately ta
king with you the packaging of the detergent.
•
Fill detergent tank with an appropriate cleaning agent;
•
Couple the tank on the foam spray nozzle;
•
Switch off the high pressure cleaner completely by pressing the ON / OFF;
•
Connect the foam lance to the spray
handle;
•
Restart the high pressure cleaner through the ON / OFF switch and operate the lever water
gun (aspiration and mixing are carried out automatically at the passage of water)
OPERATING INSTRUCTIONS - PURPOSE
The high pressure cleaner is designed to c
lean vehicles, machines, buildings, facades, etc. in the
private sector.
AREAS OF APPLICATION
•
Never use the machine in potentially explosive areas under any circumstances!
•
The operating temperature must be b5
°
C and +
50 °C.
•
The machine consists of
an assembly with a pump, which is encased in a shock absorbing
housing. For an optimal working position the machine comes with a lance and a non-slip
handle grip, whose shape and configuration comply
with the applicable regulations.
•
Do not cover or modify the lance or the spray nozzles in any way.
•
The high pressure cleaner is designed to be us
ed with cold or lukewarm (max. 50 °C) cleaning
agent; higher
temperatures can damage the pump.
•
Do not use water that is dirty, gritty or contains any chemical products, as these could impair
operation and shorten the life of the machine.
Water does not have to be drinking quality, but
should be clear without any particles, sludge and chemicals.
•
Accessories can be used to carry out work with foam cleaners, sand spraying.
ASSEMBLING
1.
The cleaner should be placed in a safe, flat, stable surface in the position according to Fig. 2
2.
Screw the high pressure hose onto the water outlet pipe and the spray handle by turning it
clockwise. Tighten the hose connection onto the spray ha
ndle by a spanner and onto the outlet
connector by hand. Prior to operating the machine please ensures that the high pressure hose
has been completely uncoiled. Whilst the machine is in operation the hose MUST NOT loop.
3.
Check that the filter is mounted in
the water inlet and that it is not blocked up (Fig.6).
4.
The inlet filter must always be fitted in the water inlet to filter out sand, limestone and other
impurities, as they will damage the pump valves.
CAUTION:
failure to fit the filter will invalidate
the guarantee.
5.
Screw the water inlet connector onto the water inlet.
6.
Insert the lance into the spray handle and turn it to lock it. Make sure that the spray handle is
locked in the OFF position by pulling out the locking lever and locating it on the tab in
the handle
grip (Fig.7).
7.
Mount the nozzle or any other equipment you want to use.
8.
Connect the water inlet hose (min. hose diameter 1/2”) to the high pressure cleaner and to a
non potable water means (e.g. a basin, a tank; CAUTION: suction height max. 1 m).
Ask your
local plumber about this.
9
