EN
10
8.
Connect the high
-pressure hose to the water outlet
according Fig 12.
•
Connect the other end of the high
-pressure hose to the water outlet on the
washer and twist the black rotatable end
-piece as indicated to secure the
connection.
9.
Connect the garden hose to the water inlet
according Fig. 13.
•
Connect the garden hose adaptor
(female coupler) to the water inlet of the
pressure washer, then thread your garden hose
(male end) into the garden hose
adaptor.
START-UP
Park the appliance on an even surface.
Insert the mains plug into the socket.
ELECTRIC AND WATER SUPPLY
For connection values, see type plate.
ATTENTION
Impurities in the water can damage the high
-
pressure pump and the accessories.
DRAWING IN WATER FROM THE OPEN RESERVOIRS
This high
-
pressure cleaner is suited to work with the YILI suction hose with backflow vale to
draw in surface water, e.g. from water butts or ponds.
Fill the suction hose with water.
Screw the suction hose into the water connection of the appliance and insert it into the
water source (e.g. rainwater drum).
ATTENTION
The pump of high
-pressure cleaner is not self-
priming. For this reason, the water inlet of the
cleaner
must be
placed
below the level of the
reservoir from which the water is drawn
during use.
Bleed the device as follows prior to operation:
•
Turn on the appliance “OFF/ON”
•
Unlock the lever of the trigger gun
(Fig. 8).
•
Push the lever of the trigger gun, the device will switch on
(Fig. 9).
•
Let the device run (max. 2 minutes) until the water exits the trigger gun without
bubbles.
•
Release the lever of the trigger gun.
•
Lock the lever of the trigger gun.
ATTENTION
Dry running of more than 2 minutes leads to damage of the high
-
pressure pump. If the
appliance does not build up pressure within 2 minutes, switch the appliance off and proceed
in accordance with the instructions in Chapter “Troubleshooting”.
High pressure operation
CAUTION
Keep a distance of at least 30 cm when using the jet for cleaning painted surfaces to avoid
damage.
