P-K STORM
TM
Gas Fired Boiler
Technical Service 1.877.728.5351
N
OTICE
!
The safety labels shown below are
affixed to your boiler. Although the
labels are of high quality, they may
become dislodged or unreadable
over time. Contact Patterson-Kelley
at
570.476.7261
or toll-free at
877.728.5351
for replacements.
Gas may lose its odor. Proper gas
sensing equipment and procedures
should be used for leak checks.
Failure to detect gas leaks could
result in injury or death.
Training
Proper training is the best protection against accidents. It is
essential
to read, understand, and follow the recommendations
of this manual before installing, operating, or servicing this
equipment. Failure to do so could
result in fire or explosion and
serious injury, death, and/or property damage.
Operating and service personnel must be thoroughly familiar with
the basic construction of the P-K STORM
™
ST-2500, ST-3000,
ST-3500 and ST-4000
boilers, the use and locations
of the
controls, the operation of the boilers, adjustment of their various
mechanisms, and all applicable safety precautions. If any of the
provisions of this manual are not fully and completely
understood, contact Patterson-Kelley Technical Service at
570.476.7261
or toll free at
877.728.5351
.
Hazard Warnings
Electrical Hazards
Shock Hazard!
Properly Lockout/Tagout the
electrical service and all other energy sources
before working on or near the boiler.
Shock Hazard!
Do not spray water directly on
this boiler or any electrical components.
Electrical Hazard!
Do not alter wiring
connections.
Crush Hazards
Lifting Hazards!
Use properly rated lifting
equipment to lift and position the boiler. The
load is unbalanced. Test the balance before
lifting off the floor. Do not allow personnel
beneath the lifted load. Refer to the
approximate weights in the table below
.
Boiler Model
Weight in
Pounds
ST-2500
2329
ST-3000
2329
ST-3500
2772
ST-4000
2772
Bump Hazard from Overhead Ductwork and Piping
Injury Hazard!
Install components with adequate vertical clearance.
Pressure Hazards
Pressure Hazard!
Hot fluids. Install isolation valves on boiler water inlet and outlet.
Make sure isolation valves are closed before servicing boiler.
Pressure Hazard!
Hot fluids. Annually test safety relief valve(s) for proper operation.
Do not operate boiler with faulty relief valve(s).
