7
Fitting and adjusting the harness
WARNING! Always attach the
harness when operation petrol brush
cutter. Do not carry it only with your
hands.
1) The harness helps the operator to carry
this petrol brush cutter.
2) Take the harness of the unit by opening
the karabiner.
3) Place the harness so that is runs over
the left shoulder, crossing breast and back.
The karabiner must be place at the right
hip.(Fig.11)
4) Adjust the length of the harness so that
the hook is about 15cm below your waist
and the cutting means are parallel to the
ground.(Fig.12)
V - OPERATION INSTRUCTION
WARNING! For your safety,
please read carefully the safety
warnings before operate the brush
cutter!
1
STARTING COOLING ENGINE
1) Place the petrol brush cutter on a flat
stable ground that is not flammable.
Ensure that the cutting means to not touch
any objects or the ground.
2) Set ignition switch to “I” position.
3) Move choke lever to “COLD START”
position and pump primer bulb until fuel is
visible and flows freely in the clear fuel
tank return line. Pump bulb an additional 6
times.(Fig.13)
4) Depress throttle interlock and then
depress throttle trigger, and press this
throttle safety button to lock it in half-gas
position of throttle trigger. Once the throttle
safety button is located, then release
throttle interlock and throttle trigger
synchronously.(Fig.14)
5) Pull the recoil starter to start engine and
then open choke lever. Now, your brush
cutter is under idle-speed states.
6) Let the petrol brush cutter run in idle
speed for 10-15s to let it warm up.
7) Depress throttle trigger to get full engine
speed for operation.
2
STARTING WARM ENGINE
1) Set ignition switch to “I” position.
2) Move choke lever to “WARM START”
position, do not depress primer
bulb.(Fig.15)
3) Depress throttle interlock and then
depress throttle trigger, and press this
throttle safety button to lock it in half-gas
position of throttle trigger. Once the throttle
safety button is located, then release
throttle interlock and throttle trigger
synchronously.(Fig.14)
4) Pull the recoil starter to start engine.
Now, your brush cutter is under idle-speed
states.
5) Depress throttle trigger to get full engine
speed for operation.
3
STOPPING ENGINE (Fig.16)
WARNING! The cutting means
will continue to rotate for some time even
after the engine has been switched off!
Wait until the they come to a complete
stop before you place down the petrol
brush cutter and grass trimmer!
Summary of Contents for 8302769
