EN
154
EN
155
Product overview
1
On/Off switch (with automatic pressure
switch)
2
Transport handle
3
Pressure gauge (set pressure)
4
Pressure regulator
5
Air outlet
6
Pedestal
7
Air filter
8
Wheel
9
Overload switch
10
Pressure tank
11
Safety valve
12
Condensation drain valve
13
Pressure gauge (tank pressure)
Setup
Only operate the compressor in dry rooms at
a humidity above 50% and a temperature of
+5 °C to +40 °C. Max. operation level above
sea level 1000 m. Distance to walls min.
30 cm.
Intended use
This compressor is intended for generat-
ing compressed air at max. 8 bar to operate
suitable pneumatic tools (e.g. tyre inflators,
blow-out guns, or paint sprayers). Oserve the
suction capacity according section "Technical
Data". This compressor is not suitable for run-
ning machines with high air consumption.
The tool is only suitable for operation under
supervision.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Restriction of use
DO NOT use the compressor:
- for continuous operation
- for gases other than air,
- in explosive atmospheres,
- for respiratory air (e.g. diving equipment),
- for medical use,
- for the food sector,
- for measuring, control and safety pur-
poses,
- for blow-cleaning clothes
- for commercial, trade or industrial use.
1
INSTALL THE PEDESTALS
Install the pedestals
the compressor.
INSTALL THE WHEELS
2
Install the wheels
left and right of the
compressor.
INSTALL TRANSPORT HANDLE
1
2
Secure the transport handle on both
sides with two hexagon socket screws.
Slide the transport handle
into the
two fittings.
1x
1x
1x
1x
1x
2
2
5
4
6
7
12
11
1
13
8
1
3
2
1
9
2
11
10
