GB
- 229 -
6.3. Changing the blades
Important! Risk of injury!
To remove the blades, raise the lug (Fig. 4/Item 1) and push o
ff
the
cover (Fig. 4/Item 2) in direction of the arrow.
Once you have removed the blade you will be able to see the toothed
wheels of the gear unit (Fig. 5). Make sure that no dirt gets into the
gear unit when you change the blade. To assemble, proceed in rever-
se order.
When you
fi
t the hedge cutter blade
, check the position of the
pin for the eccentric connector (Fig. 5/Item 1). Take the hedge cutter
blade and slide the eccentric mount (Fig. 6/Item 1) into position so
that the pin for the eccentric connector and the eccentric mount
fi
t
together precisely when assembled. Slot the hedge cutter blade onto
the guide pins (Fig. 5/Item 2).
When you
fi
t the grass cutter blade, check the position of the pin for
the eccentric connector (Fig. 5/Item 1) again.
Shift the eccentric mount (Fig. 7/Item 1) on the grass cutter blade to
the left or the right to
fi
nd the position at which the pin for the eccen-
tric connector (Fig. 5/Item 1) and the eccentric mount (Fig. 7/Item 1)
match up.
7. Cleaning, maintenance and ordering of spare parts
7.1 Cleaning
•
Keep all safety devices, air vents and the motor housing free of
dirt and dust as far as possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low pressure.
•
We recommend that you clean the device immediately each time
you have finished using it.
•
Clean the equipment regularly with a moist cloth and some soft
soap. Do not use cleaning agents or solvents; these could attack
the plastic parts of the equipment. Ensure that no water can seep
Anl_PE_AGS_3_6_Li_SPK7.indb 229
Anl_PE_AGS_3_6_Li_SPK7.indb 229
21.08.15 10:23
21.08.15 10:23
