EN
86
Product overview
1
Main handle
2
On/off switch
3
Auxiliary handle
4
Sanding pad
5
Sandpaper Clip
6
Dust port
7
Dust box
8
Power cord
DUST COLLECTION SYSTEM
Attach the dust box
7
to the dust port
5
.
1
Alternatively a suitable vacuum
cleaner can be connected to the dust
port
5
directly.
2
Using the tool
1.
Place the tool on the workpiece so that
the complete sanding paper is in contact.
Make sure your workpiece can not slip.
2.
To switch on the tool, switch on the on/
off switch
2
. Start working, while holding
the tool firmly with both hands at the main
handle
1
and the auxiliary handle
3
.
3.
Move the tool slowly over the workpiece in
parallel lines, circles or crosswise move-
ments and successive passes.
4.
To switch off the tool, switch off the on/off
switch
2
.
Warning!
Only switch the tool on
when the sanding paper is in full
contact with the workpiece.
Never use the tool without a dust
collection system.
Intended use
The tool is intended for dry sanding of wood,
plastic, metal as well as coated surfaces. It
is not suitable for plaster or drywall filler. The
tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Grain size
Depending on the operation purpose, choose
the correct grain size from the table below:
OPERATION
GRAIN SIZE
Removal
40 - 60
Preparation
80 - 120
Finish
180 - 240
