EN
87
SANDING PAPER / VELCRO
Remove any dust or debris from the
sanding pad
4
.
1
Use a velcro sanding paper of 90 x
187 mm. Align the holes in the sand-
ing paper with the ones in the sanding
pad
4
and press the sanding paper into
place.
2
Caution!
Make sure the tool is
switched off and unplugged.
To remove the sanding paper carefully
peel it off the sanding pad
4
.
3
Do not use the same sanding paper
for metal and wood.
SANDING ROLL / CLIPS
Remove any dust or debris from the
sanding pad
4
and open the sandpaper
clip
5
at the front of the tool.
1
Use a 90 mm wide sanding roll and cut
it to a length of 240 mm.
Place the sanding paper centric on the
sanding pad
4
. Fold the sanding paper
under the sandpaper clip
5
and close it.
2
Caution!
Make sure the tool is
switched off and unplugged.
Fold the sanding paper under the sand-
paper clip
5
and close it.
4
Do not use the same sanding paper
for metal and wood.
Turn the tool around and open the
sandpaper clip
5
at the rear of the tool.
3
