EN
86
MOUNTING THE HANDLE
Fix the handle to a handle mount
8
ac-
cording to the working method.
1
TURNING ON AND OFF
A
The tool is switched on - 1.
B
The tool is switched off - 0.
2
Using the tool
1.
Adjust the sanding arm angle and the belt
speed.
2.
Plug in the power cord
4
.
3.
To switch on the tool with the on / off
switch
11
. Start working while holding
the tool firmly with both hands.
4.
Begin sanding with light movements and
low pressure.
5.
When finished sanding, switch off the tool
with the on/off switch
11
. Wait until the
motor stops before setting the tool down.
Intended use
The tool is intended for dry sanding of wood,
plastic, metal, filler as well as coated surfaces.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Warning!
Make sure the sanding
arm points away from the handle.
Warning!
Do not clamp power tools
in any work bench.
Warning!
Do not press the spindle
lock button
12
while operating the
tool.
Product overview
1
Sanding arm
2
Belt adjusting knob
3
Slide lock
4
Power cord
5
Ventilation slots
6
Cover screw
7
Belt housing cover
8
Handle mount
9
Sanding belt
10
Housing
11
On/off switch
12
Spindle lock button
13
Speed adjustment thumbwheel
14
Angle adjusting knob
Summary of Contents for Powerfile PE-500PF
