EN
122
EN
123
PARALLEL GUIDE
Attach the parallel guide
as shown
and set the desired parallel distance.
If the tool is not in use the parallel guide
can be used as a blade guard.
1
REBATING
Attach the rebating depth guide
as
shown and set the desired rebating
distance from 0 to 15.5 mm.
1
BEVELING
The three V-grooves in the front of
the base plate
allow quick bevelling.
Place the V-groove of the desired size
on the edge and guide it along.
2
DEPTH ADJUSTMENT
To set the desired planing depth from
0 - 3 mm, rotate the depth adjustment
knob
Each click adds / decreases 0.1 mm.
1
Set the desired distance on the parallel
in order to make rabbets. Plane
as often as necessary to achieve the
desired rabbet.
2
The current depth adjustment can be
checked on the indicator of the depth
adjustment knob
2
BLADE REPLACEMENT
Use the 8 mm wrench to loosen the
three screws.
Caution!
Make sure the tool is
switched off and unplugged.
1
Adjust the height of the blade assembly
with a hex key and securely tighten the
three screws loosened in step
1
.
There are two blades on the spindle!
Caution!
Always use identical
blades and blade assemblies.
4
Replace the blade or the complete
blade assembly and slide it back into
the tool so that it runs freely.
Caution!
Make sure the blade is
placed in the correct position.
3
Open the blade cover and slide out the
blade assembly.
Caution!
The blade is sharp. Use
protective gloves.
2
4
2
2
1
1
1.
1.
2.
2.
1
1.
1.
2.
2.
3.
3.
3
2
1
2
