EN
120
EN
121
Product overview
1
Release button
2
Collecting bag
3
Depth adjustment knob
4
Planing depth scale
5
Rebating depth guide
6
Base plate
7
Parallel guide
8
Cap
9
Power cord
10
On / Off switch
DUST COLLECTION
Attach a suitable vacuum cleaner to
one of the chip extraction ports. Close
the other one with the cap
1
Alternatively lock the chip extraction
port with the collecting bag
.
Never use the tool without a dust
collection system.
2
Intended use
The tool is intended for planing and rebating
wooden materials, such as beams and boards.
It is also suitable for bevelling edges. The tool
is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Using the tool
1.
To switch on the tool, press and hold the
release button
. Then press and hold the
on / off switch
.
2.
Make sure your workpiece can not slip.
Start working, while holding the tool firmly
with both hands. Move the running tool to
the workpiece and push it forward slowly
while applying pressure on the centre of
the base plate
6
.
3.
To switch off the tool, release the on / off
switch
.
Warning!
Apply the machine to the
workpiece only when switched on.
Otherwise there is danger of kickback
when the cutting tool jams in the work-
piece.
Planing
When planing hard materials (e.g. hardwood)
and utilizing wide planer width, set low plan-
ing depth and reduce feed. Excessive feed re-
duces the surface quality and can lead to rapid
clogging of the collecting bag
To achieve high grade surfaces, work with
sharp blades, low feed and low planing depth.
Lieferumfang
Etendue de livraison
Materiale compreso nella fornitura
Leveringsomvang
Leveransomfång
Rozsah dodávky
Rozsah dodávky
Volumul livrat
Scope of delivery
DE
SV
IT
SK
FR
CZ
NL
RO
GB
1x
1x
1x
1x
1x
1x
1
9
2
6
7
10
8
4
2
1
3
5
