Patton electronics 1092RC, User Manual

Test Mode options 2,3,7,8 and 9  require the 1092RC to be in Data

Mode with the remote 1092RC.   The Model 1092RC Test Modes are
described below:  

OFF

Terminates all tests

511

Initiates the built-in test pattern generator 
and detector.

511 with Errors

Initiates the built-in test pattern generator 
and detector.  The test pattern generator 
also injects intentional errors approximately 
once per second.

Local Line Loop

Initiates the Local Line Loop test and starts 

and 511

the internal 511 generator and detector.  

Local Line Loop

Initiates the Local Line Loop test and starts 

and 511 w/errors

the internal 511 generator and detector.  In 
this test, the 511 pattern generator injects 
intentional errors into the data stream.

Remote Digital 

Initiates the Remote Digital Loopback test.  

Loop

Any data sent to the remote 1092RC is 
returned to the originating device.

Remote Digital

Initiates the Remote Digital Loopback test 

Loop and 511

and starts the internal 511 generator and 
detectors.

Remote Digital

Initiates the Remote Digital Loopback test

Loop and 

and starts the 511test patterns.  In this test

511 with errors

the 511 pattern generator will inject initial 
errors into the data stream.

The Modem Status Screen is displayed upon initiating a test.  A

511 error counter is displayed to indicate errors.  Press the ‘C’ key to
clear the counter and redisplay the Modem Status Screen.  Pressing
‘ESC’ returns you to the Test Mode Menu.

18

3.2.2  Configuring the Remote 1092RC

To configure the remote 1092RC, make a selection from the

following REMOTE UNIT CONFIGURATION MAIN MENU.  To return to
the  LOCAL 1092RC MAIN MENU screen, press [ESC] and refer to

Section 3.2.1

.

REMOTE MAIN MENU Option 1: Display Remote Unit Configuration

Select Option 1 to display the configuration of various parameters in

the remote Model 1092RC.  

19

REMOTE UNIT CONFIGURATION

MAIN MENU

1.  Display Remote Unit Configuration
2.  Setup Remote Unit Configuration
3.  Display Remote Modem Status
4.  Select Hardware /Software Control
5.  Restart Remote Unit

REMOTE CONFIGURATION

CONFIGURATION DISPLAY MENU

1.  Display Configuration of:

DSR during Local Line Loop
Response to Remote Digital Loop
Clock Mode

2.  Display Configuration of:

Configuration Control
DTE Rate

3.  Display Configuration of:

DTE Controlled Local Line Loop
DTE Controlled Remote Digital Loop