3.0 CONFIGURATION
This section describes the location and orientation of the Model
1092RC’s configuration switches and jumpers, and provides detailed
instructions for all possible settings.
3.1 CONFIGURING THE HARDWARE SWITCHES
The Model 1092RC Series front card defaults to the use of
hardware switches for configuration. There is an interface driver board
strap, and two eight-position DIP switches, on the front card (see
Figure 1, below).
Figure 2 shows the orientation of the DIP switches with respect to
the “ON” and “OFF” positions.
5
ON
12345678
ON
12345678
Figure 1.
Model 1092RC, showing configuration switches and interface board
SW1
SW2
Interface
Driver
Board
THIS SIDE UP FOR V.35
FRONT
Figure 2.
Close up of configuration switches (both sets are identical in appearance)
NOTE:
The ON position is oriented toward the front of the Model 1092RC.
ON
1 2 3 4 5 6 7 8
OFF
ON
Front Panel
ON OFF
APPENDIX A
PATTON MODEL 1092RC SPECIFICATIONS
Transmission
Format:
Synchronous or asynchronous
Transmission Line:
Single unconditioned twisted pair
Clocking:
Internal, external or receive recover
Distance:
Up to 10.8 miles (17.3Km), all data rates, 19
AWG (.9mm)
Up to 7.2 miles (11.5Km), all data rates, 22
AWG (.6mm)
Up to 5 miles (8Km), all data rates, 24AWG
(.55mm)
Up to 3.41 miles (5.45Km), all data rates, 26
AWG(.4mm)
Data Rates:
Sync
32, 56, 64 & 128 kbps;
Async
0 - 38.4 kbps
Diagnostics:
V.52 compliant bit error rate pattern
(511/511E pattern) generator and detector
with error injection mode; Local Line
Loopback and Remote Digital Loopback,
activated by front panel switch or via serial
interface
LED Indicators:
TD, RD, CTS, CD, DTR, NS(no signal),
ER (error) and TM (test mode)
Connectors:
RJ-45 on line side; DB-25 female or M/34
female on serial interface side, depending
upon which interface rear card is installed.
Temperature:
32-140°F (0-60°C)
Altitude:
0-15,000 feet (0-4572 meters)
Humidity:
5 to 95% noncondensing
Dimensions:
Front Card: 4.81” x 3.10” x 0.95”
(12.2 x 7.8 x 2.4cm)
Rear Card: 3.33” x 2.8” x 0.95”
(8.4 x 7.1 x 2.4cm)
Weight:
Front Card: 0.22 lbs (.10Kg)
Rear Card (M/34 with V.35 interface): 0.16
lbs (.07Kg)
Rear Card (DB-25/RS-232 interface): 0.12
lbs. (.05Kg)
32
Summary of Contents for 1092RC
