Wiring the power
18
EnviroNET User Manual
2 • Installing the EnviroNET
Connecting the power cable wires to the EnviroNET
To connect the power cable wires to the EnviroNET:
1.
Run the power cable wires from outside of the EnviroNET through the unscrewed gland (on the far left)
to the inside of the unit.
2.
Connect the power cable wires to the external power connection block that is labeled,
E N L
, as described
in
table 2
. (Also, see
figure 6
).
Figure 6. Connecting the power cable wires to the EnviroNET
3.
Be sure to leave a little slack on the wires so that they are not stressed or pulled too tightly. Also, make sure
that the power cable wires are secured tightly in the
E N L
block.
4.
To ensure that the cables are properly secured in the gland, tighten the gland by turning the loose pieces all
the way to the right using a Crescent® (adjustable) wrench.
Table 2. Power cable wires
Designated Slot
Power Wire (Color)
Earth (E)
Green
Neutral (N)
White
Line (L)
Black
AC IN
100-240V
0.15A
50/60Hz
POWER
BLOCK
DC OUT
12V/0.42A
PWB-5002
E
N
L
