Managing H.110 Slots
81
FS6300 NMS Administrator’s Reference Guide
4 • Configuring Maps
Figure 67. Reserve H.110 Slots for Non-Managed Cards
To reserve H.110 slots for unsupported cards:
1.
Click on
For Non-Managed Cards
(under
Reserve H.110
) from the menu on the left. Select the
Geo-
graphic Area Node
and
Chassis
holding the unsupported card(s) from the corresponding drop-down
menus.
2.
Specify the purpose of blocking the H.110 ports (
Status of H.110 Ports and Time Slots
)–
– Select
Currently In Use
if you are you providing details of H.110 ports and time slots already used
between two unsupported cards in the chassis.
– Select
Reserve for Later Use
if you are reserving H.110 ports in the chassis for future use between two
unsupported cards.
3.
Enter the
IP Address
of (or select from the corresponding drop-down menu) the unspported card and the
Slot Number
in which it currently exists. Once a card IP is entered into the system, it is listed for selection
so that you may not re-enter the same address.
4.
Next, select the
Tx-Port Number
and enter the
Tx-Time Slots
. Repeat for the
Rx-Port Number
and
Rx-
Time Slots
.
Note
It is not required to
precisely
specify the Tx and Rx Port Numbers and Time
Slots because this is only a 'reservation mechanism' (an interim solution).
However, it is essential to specify the slots actually in use or slots that need to
be reserved.
5.
Click
Submit
. The information you entered will display in a table. You may delete or edit information in
this table by seclecting the row of the information you would like to modify and clicking the
Edit
or
Delete
buttons.
