Download
250
Model 1001MC Operations Guide
10 • HTTP/HTML web page reference
•
1001MC with access to the LAN.
Note
For help, type
help
at the FTP prompt for a list of the commands.
1.
At the
C:\>
DOS prompt on the PC, type the following:
ftp <IP ADDRESS>
where
<IP ADDRESS>
is the IP address of the 1001MC.
The 1001MC will respond with the following:
Connected to <IP ADDRESS>
220 Code download service ready
User ( < IP ADDRESS > (none)):
2.
To download 1001MC operational code enter the username as
KillImage
(1001MC commands are case-
sensitive so type it exactly as shown).
The 1001MC will respond with the following:
331 User name okay, need password.
Password:
3.
Enter the superuser password for the box—the default password is
superuser
, but it may have been changed
by the system administrator, in which case, use the new password.
The 1001MC will respond with the following:
230 User logged in, proceed.
4.
The type of file being downloaded needs to be specified, type the following at the prompt:
FTP> “type image”
The 1001MC will respond with the following:
200 Command okay.
5.
Send the file by typing the following:FTP> “send <filename>” where
<filename>
is the full filename of the
file to be downloaded, including the directory (for example:
c:\temp\1001MC.img
).
The 1001MC will respond with the following:
Response: 200 Command okay.
150 File status okay; about to open data connection.
226 Closing data connection.
Connection closed by remote host.
There will be a few second delay after the data connection is opened while the file is being transferred, then the
connected will be closed. The 1001MC will automatically install the new software.
