OnSite Expansion Modules Quick Start Guide
5
3.2 Getting Started
The 3-port DS3/E3 module supports insertion into or removal from any available expansion slot on the modular
OS1052 and OS1063 chassis while the system is powered on and carrying traffic. The following procedure
applies to module insertion into a system after the power is turned ON:
•
After the module is securely installed to the chassis (using the mounted screws on the front panel), the STATED
of the module becomes a solid amber light for about ten seconds after the system detects the module.
•
After the STAT LED turns off, use the OS-10 Node Manager to set the Administrative Type for the slot wherehe
module resides
•
The STAT LED of the module becomes a solid green light when the Administrative Status of the module is set
tonabled and the Operational Status is in service (IS).
•
At this point, the module is now ready for the provisioning of services using the OS-10 Node Manager or
EMS.
4.0 Model 9200 Ethernet Module
4.1 Unpacking and Installation
To install the HD-ENET module, follow the procedures in Chapter 8 of the
OnSite Series Administrator’s Reference
Guide
. Figure 1 shows the alignment and insertion of the HD-ENET module into one of the available expansion
slots of a modular OS-10 Series platform.
Note
Hot swapping the HD-ENET module is supported on the OS1052 and OS1063 platforms.
Figure 4.
Installing the HD-E1 module
